Check niche edges and small cuts
Locate a niche edge within a course, then compare a full-tile start with a shifted dry layout.
Find the joint beside the opening
Measure from the layout origin to the edge of the finished opening you care about. In the default example the fourth course begins at 900 mm. A niche edge at 903 mm lies 3 mm into that tile. The worksheet reports the course and the distance into the face or joint.
Read a narrow cut in context
A 2,260 mm clear span with a 300 mm pitch starts its eighth course at 2,100 mm and leaves a 160 mm face. The same span lined up on a different origin gives different end cuts. Lay out both ends of the wall and both sides of the opening before choosing a starting line.
Daltile describes shifting a center line when the layout leaves a wall cut narrower than half a tile. Its floor guide asks installers to repeat that check along both directions. This worksheet uses a full-tile start so you can examine one run at a time. Daltile wall tile installation guide · Daltile floor tile installation guide