Tile Cut Desk
← Tile Cut Desk

Read and print the course marks

Transfer a calculated story pole to a scrap strip and distinguish tile-face marks from joint marks.

Choose a fixed zero

Use the same reference point for the wall, the dry run and the story pole. Measure the available clear span above the starting allowance. Write the starting direction on the strip so that turning it around cannot reverse the marks.

Transfer paired marks

For a 297 mm face and 3 mm joint, course one extends from 0 to 297 mm. Course two begins at 300 mm. Mark and shade the narrow strip between 297 and 300 as a joint. Work from zero for every measurement to avoid adding rounding error from one mark to the next.

CourseStart (mm)Face end (mm)
10297
2300597
3600897
49001197

Check the last course in place

The printed sheet is a list of tape measurements. It does not print a life-size ruler. Hold your marked strip against several points on the actual wall, including both ends. A wall that is out of level can produce different cuts at the same course.

Lay out a wall →

Layout notes