Tile Cut Desk
← Tile Cut Desk

Measure an actual tile run

Use a small dry layout to estimate the average tile face and see how the nominal size affects your final cut.

Start from two cut edges

Lay several tiles in the direction you intend to stack them. Insert the chosen spacers. Measure from the first outside face to the last outside face along a single straight line. Count only the joints inside your tape marks. Four tiles normally enclose three joints.

Daltile’s wall instructions use a loose row and evenly spaced joints to check where end cuts fall. Repeat your measurement on another selection from the batch if you see size variation. Daltile wall tile installation guide

A worked calibration

Suppose four tiles and three 3 mm joints measure 1,197 mm. Remove the 9 mm of joints and divide by four. The average tile face is 297 mm. The repeating pitch from the start of one tile to the start of the next is 300 mm.

At seven pitches, a layout based on a nominal 300 mm face plus 3 mm joints predicts 2,121 mm. The measured run predicts 2,100 mm, a difference of 21 mm before the next course begins.

Lay out a wall →

Layout notes